Vacuum filter
Rinse with water only, if your model's filter is washable, then let it dry for 24 hours. A damp filter can damage the motor.
Precautions
- Check the manufacturer's instructions
- Disconnect from the power supply first
Step by step
A filter clogs as it does its job. Shark says less airflow means less suction and more work for the motor.
A name on a step means it is that maker's or body's instruction for its own products. Your manual comes first.
Washing a filter
- Unplug the machine and check your booklet for where the filters are and whether yours can be washed.
- SharkNinjaTap foam and felt filters over a bin first to knock out loose dust.
- Rinse with water only, no detergent, and squeeze gently until the water runs clear. Keep filters out of the washing machine.
- SharkNinjaAvoid twisting or wringing a post-motor filter.
- Let it dry for at least 24 hours, until completely dry, and only then put it back.
How often
- SharkNinjaMany Shark models rinse pre-motor filters monthly and post-motor filters every 9 to 12 months. Your booklet has the figure for your model.
Where makers differ
| Question | Maker | What it says |
|---|---|---|
| What temperature of water? | Dyson | Cold water only. |
| SharkNinja | Lukewarm running water. | |
| Where should it dry? | Dyson | In a warm place. Not in a tumble dryer or microwave, or near a naked flame. |
| SharkNinja | Air dry only. Not on a radiator or in a tumble dryer. |
If something is wrong
SharkNinjaSuction is still poor after washing the filter
Likely cause: A blockage in the hose or floorhead can also reduce suction.
Check: Unplug the machine and look through the hose and floorhead.
SharkNinjaThe filter stays discoloured or no longer fits
Likely cause: Filters wear out, and cleaning does not reverse that.
Check: Replace it with a genuine filter for your model.
Stop if
- SharkNinjaThe filter is still damp. Shark says moisture can damage the motor, so give it longer.
Sources for these steps (2)
- Replacing, washing and cleaning Dyson filters · Dyson
- How to clean your Shark vacuum filters · SharkNinja UK
In detail
A vacuum filter traps fine dust before the air leaves the machine. As it clogs, airflow falls, suction drops and the motor works harder. Shark says this directly, and adds that a blocked hose or floorhead causes the same symptom, so check those too if a clean filter does not help. Dyson and Shark both say water only, no detergent and no washing machine, and both allow at least 24 hours to dry. Shark says a damp filter can damage the motor. They differ on some details, such as water temperature, and their intervals depend on the model. Not every filter can be washed. Check your booklet before wetting one, and replace any filter that is torn, no longer fits or does not improve with cleaning.
Sources for this page
Sources
Replacing, washing and cleaning Dyson filters
Dyson · Manufacturer documentation
Relied on for: Cold water, no detergent and drying for 24 hours. (states this directly)
How to clean your Shark vacuum filters
SharkNinja UK · Manufacturer documentation
Relied on for: Airflow and motor strain, water only, drying, intervals and replacement. (states this directly)