Low-pressure washing
Start with the lowest pressure that works and go up only if you must. The conservation rule, and the sensible default outdoors.
Precautions
- Test on an inconspicuous area first
- Rinse thoroughly afterwards
Using this method
Household and professional
Water softens and carries dirt, with a soft brush and mild detergent doing what pressure would otherwise do.
What it is for
- General surface dirt on masonry and paving.
- Pollen, dirt and the mould feeding on them on composite decks.
Where sources support it
- Softer natural stones such as sandstone and limestone.
- Historic masonry, as the starting point.
Where to avoid it
- Bare concrete in quantity. Kärcher says it absorbs liquid quickly, so use little water.
These lists are not complete. Something missing from them has not been cleared.
What you need
- A hose, soft bristle brush and pH-neutral soap.
How to run it
- Raise the pressure only as far as the test patch shows it is needed.
How far it goes
- It will not shift every stain. Treat those separately, testing first.
Common mistakes
- Leaving detergent behind. The film attracts dirt or dries as a film.
How to decide
- Outdoors, start here. Move to more pressure only on a surface known to take it.
Related methods
Sources for this method
- Keeping It Clean: Removing Exterior Dirt, Paint, Stains and Graffiti from Historic Masonry, US National Park Service
- Patio and deck cleaning, Kärcher
- How to clean a Trex deck, Trex
In detail
Low-pressure washing means water from a hose or a washer on its gentlest setting, with a soft brush and a mild detergent if needed. A US National Park Service handbook on historic masonry starts here, raises the pressure only as needed, and treats the test patch as the standard for the whole job. Kärcher gives the same logic for paving: softer stones such as sandstone and limestone take low pressure only, or hand cleaning with pH-neutral soap and a brush. Marshalls warns that power washing used to excess shortens the life of paving. Rinse properly. A detergent film left behind attracts dirt, as both the handbook and Trex's decking guide warn.
Sources for this page
Sources
Keeping It Clean: Removing Exterior Dirt, Paint, Stains and Graffiti from Historic Masonry
US National Park Service · Government or regulator
Relied on for: Starting at the lowest pressure, test patches and film. (states this directly)
Kärcher · Manufacturer documentation
Relied on for: Low pressure or hand cleaning on softer stones. (states this directly)
Cleaning & Maintenance Guidelines — Gardens & Driveways
Marshalls plc · Manufacturer documentation
Relied on for: Excess power washing and paving life. (states this directly)
Trex · Manufacturer documentation
Relied on for: Dirty water drying to a film. (states this directly)