Uncured epoxy resin
Sticky resin that has not set. It is a skin-sensitising hazard, solvents must never be used on skin, and what works on the bench is not what works on you.
Precautions
- Wear gloves
- Ventilate the area
- Check the manufacturer's instructions
What to do, by surface
Resin and hardener that have not finished reacting. It can still be wiped up now, which may not be possible once it has set.
Fresh or old: Time is everything. Permabond's advice is to remove the excess before it cures, because cured epoxy is very tough.
Hard surfaces
- PermabondLift the bulk off with a scraper or spatula before it sets.
- PermabondCheck the resin's safety data sheet for protection and test any solvent on a discreet area, because solvents can dissolve plastics.
How firm this is: Rests mainly on one good source. An industrial maker's advice. Keep solvents off skin, and follow the precautions on this page if resin reaches your skin.
Sources for these steps (1)
- Removing cured and uncured industrial adhesives · Permabond
In detail
The rules depend on where the epoxy is. This guidance comes from west system, an epoxy maker, for its own products. For other resins, follow the data sheet. On skin, never use solvents. Resin and mixed epoxy do not dissolve in water, so the maker says to use a waterless skin cleanser. Hardener does dissolve in water and comes off with soap and warm water. On a work surface, scrape up as much as you can, then follow with absorbent towels. Use sand, clay or another inert absorbent for a large spill, and do not use sawdust on hardener. The maker says resin or mixed epoxy residue can then be cleaned with acetone, lacquer thinner or alcohol, following the warnings on the solvent. Hardener residue takes warm soapy water. On clothes, change straight away. Do not wear them again until any mixed epoxy left on them has fully cured, which the maker says can take over two weeks. Solvents can harm many surfaces, so check the material first.
What works
Acetone is effective against uncured epoxy resin Supported
For residue on work surfaces only, and never on skin.
Sources for this page
Sources
WEST SYSTEM · Manufacturer documentation
Relied on for: The separate handling of skin, surfaces and clothing, the ban on solvents on skin, the spill procedure, and the solvents named for resin residue. (states this directly)